Configure Dlink Range Extender via WPS Button to Extend Network

Configuring your Range Extender is probably the most sought-after thing because when your home is quite big and you have a requirement of having seamless internet connectivity all across the length and breadth of your home then the best that can be done is to buy one Range Extender and get it paired with your Wi-Fi.

The same applies when you are using a Dlink Range Extender to augment the reach and extent of your Wi-Fi device which simply calls to configure Dlink Range Extender via WPS button for better internet connectivity.

It’s really true and feasible that you can configure Dlink Range Extender via WPS button with nothing big and extra required to be done as you are simply required to peruse and follow this very useful guide that lays down ways and means to configure Dlink Range Extender via WPS button quite conveniently.

So, just have a look at this pretty beneficial guide for moving on to configure Dlink Range Extender via WPS button.

Configure Dlink Range Extender via WPS Button in a Few Simple Steps

Step 1 - Just go plugging in your Range Extender into the Power outlet that lies near your main router/AP.

Step 2 - Now continue by pushing the WPS button on your primary router followed by pressing the WPS button on your Range Extender. 

Note A - Please note that there should not be any substantial lag in pressing the WPS button of your Range Extender as you should be carrying out this pairing operation instantaneously.

Note B - You also have to ensure that the WPS LED light on either of your devices must blink individually for a while after you push or press the WPS button on either of the devices otherwise you will have to press the WPS button again to see that the WPS light blinks for a couple of seconds after you have pressed the same.

Step 3 - Since the operation to configure Dlink Range Extender via the WPS button takes a couple of minutes after you have executed the above steps you must obtain the confirmation that your Dlink Range Extender pairing has set in by observing the blinking of the LED giving an indication of the start of Wireless Signal on your Range Extender WPS.

So, if this LED is ON irrespective of the color of the LED it would be safe to assume that the process to configure Dlink Range Extender via WPS button has actually come into being.

Note C - But if the LED signal doesn’t blink then you must go repeating the pairing process again and must check for the connection or the expected pairing of your Dlink Range Extender with your router.

Note D - If despite following the above-streamlined process your Dlink Range Extender doesn’t get paired up with the router then you are advised to refer to the FAQs of your Dlink Range Extender’s user manual.

Note E - You must also not forget that sometimes Dlink Range Extender gets paired up with the router only in one frequency band which may also be a sure shot cause of your DLink Range Extender not getting paired up with your router.